Top 9 30A Charge Controller – Renewable Energy Controllers

As an Amazon Associate I earn from qualifying purchases.

1. Renogy

#ad

Renogy Wanderer Li 30A 12V PWM Negative Ground Charge Controller Compatible with Lithium, Sealed, and Flooded batteries and Renogy Bluetooth Module, Gel

#ad
Renogy #ad - Simple install: fully open the hatch CCW, insert the appropriate wires, and completely close the hatch CW. Multiple led indicators for easy to read charge status and battery information.

Then secure each cable by rotating the screws clockwise CW to the closed position. Optimized for a 12v system; Deep cycle Sealed, Gel, Flooded, and Lithium battery option ready. Wanderer10a|30a installation notes: the default starting position of the wanderer controller terminal hatches are closed in the UP position that could mistakenly look like an open wire hatch. Make sure to first lower each terminal hatch by screwing the terminals counterclockwise CCW to expose the wire terminal hatch to the open position.
BrandRenogy #ad
ManufacturerRenogy #ad
Height1.76 Inches
Length6.45 Inches
Weight0.29 Pounds
Width4.31 Inches
Part NumberRNG-CTRL-WND30-LI
ModelCharge Controller

2. Binen

#ad

30A Solar Charge Controller, Solar Panel Charge Controller 12V 24V Dual USB Charge Regulator Intelligent, Adjustable Parameter Backlight LCD Display and Timer Setting ON/Off Hours 30A

#ad
Binen #ad - Lcd display: comes with a display that can clearly indicate the status and data, it can be conveniently switched modes and parameter configuration, suitable for home, industrial, commercial etc.30a solar charge controller : binen solar charger controller are ul 1741 certified, the solar charger controller compatibility with 12V 24V system.

Dual usb output 5V/2. 5a max, build-in industrial micro controller, to support mobile phone chargeing. Discharge current: 10A, automatically manage the working of solar panel and battery in solar system. For protecting the lifespan of your battery, lithium, GEL, Liions, once the voltage of the battery drop below 8V, AGM, the solar controller will turn off automatically. Easy to install and operate: the charge controller should connect the battery first, then the solar panel, low heat production. For protecting the lifespan of your battery, once the voltage of the battery drop below 8V, over-load protection.

Fully 3-stage pwm charge management, open-circuit protection, reverse protection, the solar controller will turn off automatically. Multiple protection functions: binen solar controller has short-circuit protection, improve system efficiency and prolong the life span of the battery. Please be careful to install the charger controller on a flat, and finally the load! The disassembly sequence is contrary to the wiring order. Dual mosfet Reverse current protection, well-ventilated place.
BrandBinen #ad
ManufacturerBinen #ad
Height1.97 Inches
Length3.94 Inches
Weight0.44 Pounds
Width1.97 Inches

3. Renogy

#ad

Gel, Flooded and Lithium Batteries, Compatible with Sealed, Renogy Adventurer 30A 12V/24V Negative Ground PWM Flush Mount Charge Controller with LCD Display

#ad
Renogy #ad - 4a usb port on the front display can be used to charge mobile phones, speakers, tablets, etc. Any negative connection on the solar module, battery and load can be safely earth grounded as required. 5v 2. Backlit lcd screen for displaying operating information and error codes.

Designed to cleanly flush mount on walls, providing a sleek, integrated look. Rs232 port allows communication with BT-1 Bluetooth module and usage of Renogy BT smartphone app. Compatible with 12v and 24v system; Deep cycle Sealed, Gel, Flooded and Lithium battery option ready. This ensure compatibility with any negative ground system, which is the standard and most conventional way of grounding.

An included surface Mount Attachment allows for versatility in mounting. Smart 4 stage pwm charging bulk, overcharging, float and Equalization and temperature compensation increases battery life and improves system performance. Intelligent protection against: reverse polarity, Boost, short-circuit and reverse current. The adventurer is a negative ground controller.
BrandRenogy #ad
ManufacturerRenogy #ad
Height1.9 Inches
Length6.56 Inches
Weight0.45 Pounds
Width4.5 Inches
Part NumberRNG-CTRL-ADV30-LI
ModelAdventurer 30A Li 12V/24V
WarrantyNEVER connect the solar panel array to the controller without a battery. Battery must be connected first. This may cause a dangerous occurrence where the controller would experience a high open circuit voltage at the terminals. • Ensure input voltage does not exceed 50 VDC to prevent permanent damage. Use the Open Circuit (Voc) to make sure the voltage does not exceed this value when connecting panels together in series. • The charge controller should be installed indoors in a well-ventilated, cool, and dry environment. • Do NOT allow water to enter the controller.

4. EEEKit

#ad

Multi-Function Adjustable LCD Display with Timer Setting On/Off Hours, EEEKit 30A Solar Charge Controller, Dual USB Port Solar Panel Battery Intelligent Regulator, 12V24V 30A

#ad
EEEKit #ad - Dual usb 5v/3a output ports support mobile phones, tablet PCs or other devices that require 5V voltage. Wide compatibilitythe solar charger controller with 30a rated discharge current is compatible with 12V or 24V system automatically, AGM, suitable for lead-acid batteries: OPEN, GEL.

Reliable protectioneeekit solar charge regulator provides over-current protection, short-circuit protection, low voltage and overcharge protection, inverse connection protection, a reliable protector for your devices. Easy to usethe charge controller should connect the battery first, then the solar panel, and finally the load! You can change the settings by the simple one-button operation.

Intelligentbuild-in industrial microcontroller for automatical management, memorizing various parameters set by the user and the data won't be lost when the battery runs out. Functional lcd displayintuitive lcd display that can clearly indicate the status and data is able to switch modes and parameter configuration, commercial, industrial, suitable for home, etc. The solar controller will turn off automatically once the voltage is too low.
BrandEEEKit #ad
ManufacturerEEEKit #ad
Height2.5 Inches
Length7 Inches
Width13.5 Inches
Part NumberH026100-E008135338

5. Phoenician Energy

#ad

Solar Panel Charge Controller 30Amp Solar Regulator with Dual USB LCD, Phoenician Energy 30A Solar Charge Controller 12V/24V Auto, Backlight LCD Display and Timer Setting ON/Off 30A

#ad
Phoenician Energy #ad - The charge controller should connect the battery first, then the solar panel, and finally the load! The disassembly sequence is the reverse. This solar charger controller equipped with industrial-grade STM 8 microprocessor to control the charger and discharge process.

The solar regulator is only suitable for lead acid batteries: open, not for nickel hydride, or other batteries. Battery voltage: 12v/24v auto; rated charge & discharge current: 30A; Settable operating modes of loads, Equalization, Adjustable power rate with dual USB ports; 4-StageBoost, ABS, Float. For protecting the lifespan of your battery, Liions, once the voltage of the battery drop below 8V, AGM, GEL, lithium, the solar controller will turn off automatically.

Easy to use: solar controller comes with a backlight display that can clearly indicate the status and data, it can be conveniently switched modes and parameter configuration. Suitable for home, and other small solar systems. Mutiple electric protection: short-circuit protection, reverse protection, open-circuit protection, industrial, commercial, over-load protection. Solar charge controller with dual usb ports, usb output: 5v/2a max.
BrandPhoenician Energy #ad
ManufacturerPhoenician Energy #ad
Weight5.5 ounces

6. Renogy

#ad

Gel, Grey, Renogy Rover 30 Amp 12V/24V MPPT Solar Charge Controller Battery Regulator Compatible with Lithium Sealed, Flooded Batteries & Bluetooth Module

#ad
Renogy #ad - Intelligent protection built-in against reverse polarity, overload, short-circuiting, over-discharging, overcharging, and reverse current. Compatible with 12v and 24v systems. Positive ground controller featuring innovative mppt maximum power point tracking technology with high tracking efficiency up to 99%, maximizing the energy from solar panels to charge your system.

Power source type: Solar-Powered. Lcd screen and multiple led indicators for displaying system operation information, customizable parameters, and error codes. Aluminum heat sink allows for efficient heat dissipation.

Also compatible with various Deep Cycle battery options: Sealed, Gel, Flooded, and Lithium 12.8v lfp. 4-stage charging bulk, boost, Float, and Equalization and temperature compensation increase your battery life and improve your system's performance. Rs232 port allows the rover pg to communicate with the BT-1 Bluetooth module, which can pair with the Renogy BT smartphone app.
BrandRenogy #ad
ManufacturerRenogy #ad
Height4 Inches
Length10 Inches
Weight4 Pounds
Width7 Inches
Part NumberRNG-CTRL-RVRPG30
ModelRover 30 Amp 12V/24V

7. Renogy

#ad

Renogy Rover 30 Amp 12V/24V DC Input MPPT Solar Charge Controller Auto Parameter Adjustable LCD Display Solar Panel Regulator fit for Gel Sealed Flooded and Lithium Battery

#ad
Renogy #ad - Error code detection for easy self diagnoses. Automatically detect 12v or 24v dc system voltages innovative mppt technology with High tracking efficiency up to 99% and peak. Reverse protection: any combination of solar module and Battery, and lithium.

Electronic protection: overcharging, Flooded, overload, over-discharging, without causing damage to any component. Compatible with various deep cycle battery options: sealed, float, gel, boost, and short circuit. Charges over-discharged Lithium-Ion batteries. Conversion efficiency of 98%. 4-stage charging: bulk, and equalization and LCD screen with programmable charging parameters.

Customizable charging voltages. Die-cast aluminum design for heat dissipation and the capability of measuring the battery's temperature and remote monitoring. Rs232 port allows the rover to communicate with the bt-1 Bluetooth module, which can pair with the Renogy BT Smart phone app.
BrandRenogy #ad
ManufacturerRenogy #ad
Height2.85 Inches
Length9.37 Inches
Width6.81 Inches
Part Numberfit for Gel Sealed Flooded and Lithium
Modelfit for Gel Sealed Flooded and Lithium

8. EPEVER

#ad

EPEVER MPPT 30A Solar Charge Controller, 30 Amp Solar Charge Regulator Mppt 12V/24V Auto Max 100V Input Negative Grounded Controller with LCD Display for Gel Sealed Flooded Lithium Battery Charging

#ad
EPEVER #ad - Real-time energy recording and statistical. Auto control system to limit the charging power & current go over the rated value. 30 amp charge controller max input solar panel power: 390w/12V, 780W/24V.

Max input Voltage: 100V. It protect the battery from being over-charged by the solar modules and over-discharged by the loads. Mppt solar charge controller 30a: 12v/24v auto identifying system volt. Solar panel charge regulator with rs485 interface, it can be monitored by cellphone APPeBox required, PC Software and MT50 remote meter. Quick technical Support [email protected] Com. 30a solar controller mppt support for 4 type battery charging: lead-acid sealed, AGM, Flooded, Gel, User and Lithium.

Available to meet various communication requirements in different situations. Solar RV, etc. Battery temperature compensation function to ensure the controller’s life. Mppt solar regulator can be widely used for various applications, household system and industrial field monitoring, e. G.
BrandEPEVER #ad
ManufacturerEPEVER #ad

9. PowMr

#ad

30A Solar Charge Controller 12V/24V Auto, Solar Panel Charge Controller 30Amp Solar Regulator with Dual USB LCD, Adjustable Parameter Backlight LCD Display and Timer Setting ON/Off Hours

#ad
PowMr #ad - Mutiple electric protection: short-circuit protection, open-circuit protection, suitable for home, over-load protection, industrial, commercial, reverse protection, Good Heat DissipationDual mosfet Reverse current protection, etc small solar system, more safty for using, low heat productionavoid direct sunlight exposure or damp place.

Battery voltage: 12v/24v auto; rated charge & Discharge Current: 30A; Settable operating modes of loads, Float. This solar charger controller equipped with industrial-grade STM 8 microprocessor to control the charger and discharge process. The power mosfet is used as and electronic switch without any mechanical switches. For protecting the lifespan of your battery, the solar controller will turn off automatically. Easy to use: solar controller comes with a backlight display that can clearly indicate the status and data, then the solar panel, it can be conveniently switched modes and parameter configuration.

The charge controller should connect the battery first, and finally the load! The disassembly sequence is contrary to the wiring order. The solar regulator is only suitable for lead acid batteries:open, lithium, Liions, once the voltage of the battery drop below 8V, not for nickel hydride, agM, GEL, or other batteries. Solar charge controller with dual usb ports, Equalization, adjustable power rate with dual usb ports; 4-StageBoost, abs, USB Output: 5V/2A max.
BrandPowMr #ad
ManufacturerPowMr #ad